Showing results: 1411 - 1425 of 2628 items found.
-
OMA-100 -
Focused Photonics Inc.
OMA-100 gas online analyzer is a new generation of online gas analyzers which was independently developed based on the world's leading non-dispersive infrared gas analysis technology. It adopts a half-air chamber gas circuit design, with higher measurement accuracy, lower drift, and less influence from external interference (temperature fluctuati
-
Osborne Transformer Corp.
Osborne high impedance transformers are used to step-up, step-down and isolate voltages in single phase and three phase circuits. A properly designed high impedance transformer can be used an an equivalent to an isolation transformer connected in series with an inductor. The high impedance characteristic may be employed as a current limiting feature in both the primary and secondary circuity.
-
85010113 -
Interpower Corp.
This International Socket Strip includes seven international test sockets. It includes one unterminated power cord. For 220-240 circuit: Continental Europe (CEE 7) 16A. Denmark 16A. Italy 10A. India (old British BS 546) 15A. Switzerland 10A. Australia/New Zealand 10A. United Kingdom/Ireland 13A.
-
377B26 -
PCB Piezotronics, Inc.
Open Circuit Sensitivity (at 250 Hz)Frequency Range (+2.2/-4.9 dB)2 to 20000 HzLower Limiting Frequency (-3 dB)Inherent Noise<45 dB(A) re 20 Pa Dynamic Range(3% Distortion Limit)EnvironmentalTemperature Range (Operating)-40 to +158 F-40 to +70 C[5]
-
IQD Frequency Products Ltd
Quartz crystal resonators are used in a wide range of electronic applications that require timing devices. The quality of the quartz crystal blank is critical to the performance of quartz crystal units and the high Q factor of quartz means that tight stabilities can be achieved; this is key to ensuring microprocessor timing circuits work correctly within customer’s designs.
-
AI-5620 -
Advent Instruments Inc.
The AI-5620 simulates a single port two wire analog TE (Terminal Equipment) or CPE (Customer Premise Equipment) device. It is designed to measure and analyze signals generated by a CO (central office) line card, VoIP terminal adapter FXS port, or any device utilizing a SLIC (subscriber line interface circuit).
-
FISCHERSCOPE X-RAY/XDLM -
Helmut Fischer AG
Very universal because equipped with a micro-focus tube, 4-x aperture changer and 3 primary filtersSuitable for smaller structures such as connector contacts or printed circuit boardsLarger measuring distances are possible as well (DCM, stroke 0-80 mm)Large and spacious measurement chamber with a cutout(C-slot)A programmable stage for automated measurements is available
-
HE-960HC -
HORIBA, Ltd.
FPD manufacturing processesThe HE-960HC measures conductivity, which forms the basis for parameters in chemical and waste water management. Its dual calculation circuits and software, combined with carbon sensors, enable measurements ranging without switching. The HE-960HC can be used as a process concentration meter, and also to monitor changes in the concentration of specified chemicals.
-
YB4320A -
KILTER ELECTRONIC CO.,LTD
High Sensitivity, up to 1mV/div. High Light Graduation. Alter-mag.: Normal(¡Á1)and Mag.trace can be display alternative. INT£¬auto select CH1/CH2. TV Sync£¬new designed circuit can sync TV-H,TV-V signal stable. Auto Focus, CE Approal. Trigger level lock. Component Test Function£¨YB4320B£
-
Pickering Interfaces Ltd.
The breadboard modules with digital I/O (the 40-220A series) allow the user to construct their own circuit in situations where a PXI module is not available. For example when it is required to integrate a non-switching function into a PXI chassis. Typical applications include creating custom circuitry that can be housed on a 3U board or to build special “one-off” switching modules.
-
LISN -
Com-Power Corporation
LISN stands for 'Line Impedance Stabilization Network'. Com-Power offers a line of LISNs developed for conducted emission testing according to the most commonly adopted EMC specifications like CISPR, FCC, ISO, EN, RTCA DO-160 and MIL-STD 461D. The LISN circuit is designed and constructed to meet the performance criteria given by these standards.
-
AudioJog Pro 5 -
CableJoG Ltd
ALL new Audio cable tester with SINGLE & DOUBLE ended testing. There are 2 rows of 6 LED's corresponding to each of the possible connector pins and one for the screen (or ground) connection. As each pin is activated, the LED's indicate all connections associated with that pin, so that short, open and crossed circuits can be easily found.
-
National Technical Systems
From cheap toys and smartphones to sophisticated computers and radar detector systems, printed circuit boards (PCB) are critical components for today’s electronic and industrial technology. Almost every electronic device has one of these self-contained modules of complex interconnected electronic components, which include resistors, capacitors, transistors, diodes and fuses.
-
Buckleys Ltd.
PD and PHD Pinhole/Holiday Detectors have an alarm circuit to alert the operator when a fault has been located and the required test voltage can be set on the unit's meter. Spark Testers provide an inexpensive means of testing but have no output voltage meter or audible alarm. However, they can test joints even if the backing is not connected.
-
Delta Eclipse -
Cohu, Inc.
Eclipse delivers scalable performance for testing a wide range of semiconductors, from analog ICs to high-performance CPUs and mobile processors. The Eclipse is a high-speed pick-and-place handler designed to test up to 16 Integrated Circuits (ICs) in parallel, at temperatures from -45°C to +155°C*, with throughput up to 13,000 UPH.